v0.2.11 - Unpinning module version, then will be easier to update staging servers;

v0.2.10 - Upgrading to use latest huginn EPICS module version 0.0.22

v0.2.9 - Refactoring AUTO modes engines, mainly regarding when to switch peltiers ON or OFF;

v0.2.8 - Fixing an issue in DELAY to Switch-OFF countdown logic

v0.2.7 - Cleaning; Because logic for AUTO and EXTERNAL modes in SNL are almost the same it has been decided to keep only one state for both, avoiding the duplication of very similar instructions;

v0.2.6 - Algorithm of interpolation was wrong, replaced by a new proposed on;

v0.2.5 - Rolling-back a modification; Alex H. confirmed the previous behaviour was the desired one;

v0.2.4 - Fixes after Alex H tests: in AUTO mode should always set MainCryo SETP even if not WITHIN range and also switch peltiers OFF;

v0.2.3 - More fixes after Alex Holmes tests;

v0.2.2 - Some fixes after Alex Holmes tests;

v0.2.1 - Bit more time necessary to device reset configuration;

Huginn tests;

v0.1.9 - Upgrading IOC to use module version v0.0.12;

v0.1.8 - Refactoring aSub functions; mainly due SETP_S according to MATLAB algorithms;

v0.1.7 - Redeploying due a typo;

0.1.6 - Reviewing all delays when resetting LS configs; adding a message record to show reset status;

v0.1.5 - Fixing CHANNEL names used when setting CURVES; incrementing DELAYs when setting PIDs after bench tests;

v0.1.4 - Fixing CHANNEL names used when setting CURVES; incrementing DELAYs when setting PIDs after bench tests;

v0.1.3 - Adding some delays between SET commands when resetting all configurations; adding missing INTYPEx_SET command;